Difference between revisions of "HOWTO:Using Named Paths"
From WireCAD Online Help
Wirecadadmin (Talk | contribs) |
Wirecadadmin (Talk | contribs) |
||
| Line 9: | Line 9: | ||
== Before You Start == | == Before You Start == | ||
| − | This tool assumes that you have already calculated the cable path length | + | This tool assumes that you have already calculated the cable path length. If you have a scaled floor plan consider tracing the path with a polyline from which you can measure length. Remember when using this method to add in the elevation traverses. Also, the unit of measure of the polyline length will be in DU which you must convert to your unit of measure. |
| + | |||
| + | == Adding a Named Path== | ||
Revision as of 13:50, 9 June 2011
| Command Line Shortcut: Varied User Permissions Level: All |
Contents
Before You Start
This tool assumes that you have already calculated the cable path length. If you have a scaled floor plan consider tracing the path with a polyline from which you can measure length. Remember when using this method to add in the elevation traverses. Also, the unit of measure of the polyline length will be in DU which you must convert to your unit of measure.
