Knowledge Base
Knowledge Base| Subject: | Wirecad 6 installed on new windows 10 laptop |
|---|---|
| Status |
Resolved |
| Product | WireCAD v6 |
| Product Level | XLT |
| Database Type | VISTADB |
| Build Number (last 4 digits of version) | 1639 |
Message
Customer
Hi Chris,
Hope your well!
I had to install a new hard drive and upgraded to windows 10 on my laptop. Wirecad 6, running in windows 7 compatibility mode seems to work fine.
Here is my question:
One of my older project was 'checked out' and ultimately, I can not check it in as 'the same user'.
Is there a work-around for this?
Thanks and regards, Joost
Hope your well!
I had to install a new hard drive and upgraded to windows 10 on my laptop. Wirecad 6, running in windows 7 compatibility mode seems to work fine.
Here is my question:
One of my older project was 'checked out' and ultimately, I can not check it in as 'the same user'.
Is there a work-around for this?
Thanks and regards, Joost
20-January-2016 (03:42 PM)
Hi Joost!
I am surprised that you have to run in compatibility mode. We don't have any issues running v6 through v8 on win10.
On the checked out project:
Open the checked out project.
Click Project>Project Info
On that page there will be a button the says [Check In Project].
Click that. This will remove the Checked Out flag.
I am marking this ticket resolved. If I missed the mark just reply to the ticket to re-open it.
CBH
I am surprised that you have to run in compatibility mode. We don't have any issues running v6 through v8 on win10.
On the checked out project:
Open the checked out project.
Click Project>Project Info
On that page there will be a button the says [Check In Project].
Click that. This will remove the Checked Out flag.
I am marking this ticket resolved. If I missed the mark just reply to the ticket to re-open it.
CBH
20-January-2016 (04:27 PM)
Support