Knowledge Base
Knowledge Base| Subject: | Creating a new disconnected cable |
|---|---|
| Status |
Resolved |
| Product | WireCAD v8 |
| Product Level | XLT |
| Database Type | VISTADB |
| Build Number (last 4 digits of version) | 1374 |
Message
Customer
Is there a recommended way of creating a new cable that is not connected to systems? I'm documenting existing infrastructure and need to input existing runs that are not currently being used.
Thanks!
Craig
Thanks!
Craig
25-April-2016 (03:25 PM)
I couple of ways:
1. Use the Pre-wire tool in the Plan View Tools tab.
2. Enter a new cable directly in the Cables database. This will not show in a drawing but you can put whatever data you have in the cables database.
3. Use a orphaned terminals (ctrl-double-click a terminal to edit the display without putting the entry in the Equipment List) on each end of a cable.
1. Use the Pre-wire tool in the Plan View Tools tab.
2. Enter a new cable directly in the Cables database. This will not show in a drawing but you can put whatever data you have in the cables database.
3. Use a orphaned terminals (ctrl-double-click a terminal to edit the display without putting the entry in the Equipment List) on each end of a cable.
25-April-2016 (04:39 PM)
Support
Customer
Thanks for the info!
25-April-2016 (06:07 PM)